NTC 3950 100K Thermistor with Cable for 3D Printer (Dupont connector 2 position )
- A thermistor is a resistor whose value varies with temperature. This type of device is rated at 100K ohm.
- This particular product is used as replacement 3D printers extruder and heat bed to serve as temperature sensors.
- This unit is compatible with most 3D printer makes and comes with the cable pre-attached.
- A malfunctioning thermistor can have serious influences on the quality of a 3D print.
- The unit is quite easy to replace, simply pull it out and re-tape in the new with some Kapton thermal tape.
- In dire cases, some printer firmware allows you to calibrate the temperature PID control system values.
- It comes with a Dupont connector.
- Easy to detach from thermistor whenever required.
- It is a NTC Thermistor
Specifications :
Model: 100K ohm NTC 3950 Thermistor
Nominal resistance: R25 (25°C): 100K
B value R25/50: 3950K
B accuracy: ±1%
Operating temperature range: -40°C～+300°C
Dissipation power factor: ≥5 mW/°C (in static air)
Large rated power: 45mW
Thermal time constant: ≤7S (in static air)
Resistance temperature coefficient: -2～-5%/°C
WARNING
