NTC 3950 100K Thermistor with Cable for 3D Printer (Aircraft JST)

Price:
US$4.99
3D-HE-003AC
In stock
+
Add to wish list

NTC 3950 100K Thermistor with Cable for 3D Printer (Aircraft JST)

  • A thermistor is a resistor whose value varies with temperature. This type of device is rated at 100K ohm.
  • This particular product is used as replacement 3D printers extruder and heat bed to serve as temperature sensors.
  • This unit is compatible with most 3D printer makes and comes with the cable pre-attached.
  • A malfunctioning thermistor can have serious influences on the quality of a 3D print.
  • The unit is quite easy to replace, simply pull it out and re-tape in the new with some Kapton thermal tape.
  • In dire cases, some printer firmware allows you to calibrate the temperature PID control system values.
  • It comes with a New type of JST pin.
  • Easy to detach from thermistor whenever required.
  • It is NTC Thermistor
Notice for California Residents: Warning symbolWARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov