100KG Aluminum Load Cell Sensor
This Aluminum scale can measure up to 100Kg/220lbs of. It converts the weight into electrical signals using a Wheatstone bridge formation. The output wires are the following: Red: E+, Black: E-, Green: A+ (O+) and White: A- (O-). The user must use an Amplifier when interfacing with microcontrollers. Comes with Four 7mm diameter threaded holes on each side to mount plate onto. When mounting onto base, screw on one side. When mounting underneath the top plate, mount with screws on the opposite side screw holes. The two sides with epoxy coating, adjacent to the wires is the typical location of the weight and base counterweight. This unit measures 150 x 38 x 24 mm (L * W * H) and operates from - 10°C to 50°C.
Note: Be careful when handling this device. It may contain sharp edges.
WARNING
