3D-E-015 MKS 3D Printer Hot-Bed MosFet based switch

Price:
US$29.95
3D-E-015
In stock
+
Add to wish list

MKS 3D Printer Hot-Bed MosFet based switch

This is a beefy MosFet board, you can supply up to 30Amps into this device which will be supplied to your heat-bed without worrying about burning your terminal connectors on your 3D printer controller. Simply connect 12/24 VDC cable from your power supply to the large black terminal blocks on the MosFet board with the label “POWER” located behind the black terminal block. Connect the output cables from the black terminal block labelled “HOTBED” to the heat bed. On the smaller green terminal blocks, connect the old wire that went directly to the heat-bed from your 3D printer controller into this new block on the MosFet board. Now when your controller sends a signal the signal will leave your controller from the old “HOTBED” pin enter into the green terminal block labelled “BED”. The provided optocoupler will allow you to send signals to the MosFet without worrying about voltage spikes or high current entering your 3D printer controller.  

This product is highly recommended for avid 3D printers!

Note: Heatsink colour may vary.

Notice for California Residents: Warning symbolWARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov