MOT-DRV8833 DRV8833 Dual H-Bridge Motor Controller Driver Board (1.5A)

Price:
US$3.49
MOT-DRV8833
In stock
+
Add to wish list

DRV8833 Dual H-Bridge Motor Controller Driver Board (1.5A)

This DRV8833 based DC motor controller board allows users to attach an external power source to power DC motors that require a little bit more current. Plug in an external power source up to 10.8VDC with a max current of 1.5A per channel. The IC onboard contains two h-bridges allowing the control of two independent DC motors or one 4 wire bipolar stepper motor. The design of this module also guarantees protection against overcurrent, short circuit, overheating and under voltage lockout. It also comes with a low power sleep mode.  

This module comes with straight headers that you will need to solder on the module. The pin configuration is very simple to grasp. IN1 and IN2 control the outputs OUT1 and OUT2 (1st channel). IN3 and IN4 control the outputs OUT3 and OUT4 (2nd channel). Pin EEP is for output protection and ULT is your sleep mode pin (sleep mode active when logic level low). Vcc and GND are self-explanatory.

DR8833 datasheet

Specifications:

  • Operating Voltage: 3VDC-10.8VDC
  • Dimensions: 18.5mm x 16mm / 0.7 in x 0.6 in
  • Current: 1.5A
  • Soldering required
Notice for California Residents: Warning symbolWARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov