PSM-270 4-20mA to 0-5VDC Current to Voltage Converter Module
This module is used to convert a 4-20mA current loop measurement signal to a 0-5VDC output signal. At 4mA the output voltage is 0VDC and at 20mA the output voltage is 5VDC.
Wiring Guide:
Signal Current of 0-20mA enters in with the arrow pointing towards the board and ground with the arrow pointing out.
Output Voltage leaves from Vout and Gnd.
To power the entire board to do the conversion you need, a separate constant 5vdc power source in pin VCC is required and Ground is shared with output GND.
The board has an LED to indicate when it is powered on.
Adjust using the output voltage using the potentiometer.
Specifications:
- Input Current Min: 4mA
- Input Current Max: 20mA
- Output Voltage Min: 0VDC
- Output Voltage Max: 5VDC
- Operating Temperature: -10 to 60°C
- Storage Temperature: -20 to 85°C
- Dimensions: 45 x 25 x 17mm (L x W x H)
WARNING
