HG7881 Dual H-Bridge DC Motor Drive Controller Board for Arduino
There are two HG7881 mounted onto this module, allowing users to have access to two H-Bridges. Using the H-Bridge allows users to connect and control the spin direction of the motors. You can connect a maximum of two DC motors or have four motors with one side spinning the same direction. This module is designed to work with Arduino Microcontroller.
Specifications:
- Input Voltage: 2.5v~12v in pin VCC
- Current Continuous Per Channel: 800mA
- Dimensions: 29.2 x 23 x 12 mm (L x W x H)
- Pinout with 0.1” spacing: Channel B-1, Channel B-2, VCC, GND, Channel A-1, Channel A-2
- Arduino Guide: http://www.instructables.com/id/Autonomous-Race-Car/step3/Connect-Arduino-board-and-the-ultrasonic-sensor/
WARNING
