DFR0124 RGB LED Module

Price:
US$48.93
DFR0124
In stock
+
Add to wish list

DFR0124 DFRobot RGB LED Module

This Arduino-compatible module uses three TI TLC5940 PWM LED chips to drive a 4x4 array of RGB LEDs. Each color is controlled by a different chip so you can adjust the reference resistors for the appropriate current. The TLC5940 chips are not directly connected to any Arduino pins, but a header is provided for you to make a manual connection depending on the needs of your sketch. 

Up to 16 of these modules can be serially connected to make a fantastic LED wall or a LED circle.

It can be directly connected with Arduino via F/M cables. If you want ,you can also connect it to Interface shield through an IDC2x5 cables,and then plug the Interface shield to Arduino.

NOTE: This is a Un-assembled Kit, you need soldering skill to assemble it. A tutorial is available as a reference. 

If you feel the assignment of the leds is not good enough, you could assign the LEDs in a custom pattern by wiring to the LED driving holes.
 
 
Specifications
  • Supply Power:DC 5v
  • RGB LED: common anode 
  • IDC2x5 Serial Data Interface
  • 4x4 array of RGB LEDs
  • TLC5940 LED driver
  • 16 Channels RGB LED with PWM control
  • Size:78x45x12mm
  • Interface:
    • D13(SCK) TLC5940 SCLK
    • D10(SS)        TLC5940 BLANK
    • D11(MOSI)               TLC5940 SIN
    • D9                TLC5940 XLAT
    • D3                TLC5940 GSCLK
 

Includes

  • RGB Module PCB board   (1 unit)
  • RGB LEDs               (16 units)
  • IDC10 Interface        (1 unit) 
  • TLC5940NT chips        (3 units)
  • DIP28 socket           (3 units)    
  • Jumper cap             (1 unit) 
  • 20pin row needles      (1 unit)
 
Documents               

 

Notice for California Residents: Warning symbolWARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov