Ginsberg Scientific Inc.

1 2 3 4 5 6 7 8
2 - 10
US$392.00
This is perfect for classroom demonstrations of the effect a load has on a power source. The field of this magneto consists of a single Alnico magnet, which has a strong magnetic flux density. Capable of producing higher voltages then cobalt-steel magnets. The generator is mounted on 7 5/8" x 12" wood base with incandescent lamp and socket used as a load. Two binding posts are placed on the board for attaching other loads. Complete with instructions. (16" x 8" x 6"; 6Ibs).
In stock
+
Add to wish list

US$131.29

This 36 piece Glassware Kit contains all the essential borosilicate laboratory glassware. Included are the following: Griffin beakers, one 50ml, two 250ml and one 600ml -- Erlenmeyer flasks; one 50ml, two 250ml and one 500ml --six medicine droppers -- six stir rods 6" -- one graduated cylinder 10ml -- one graduated cylinder 100ml -- one serological pipet -- twelve test tubes 16x150mm -- one short stem funnel 75mm x 75mm.

In stock
+
Add to wish list

US$128.98

With this distillation apparatus you can separate any mixture of two liquids by raising the temperature of the mixture to a point where one of the liquids will boil but the other remains liquid. Consists of: 300mm Leibig Condenser. Kjeldahl Ball 50mm in dia. 500ml Boiling Flask. Cast Iron Base with Support Rod. Clamp. Cast Iron Tripod. Wire Gauze. 500ml Erlenmeyer Flask.

In stock
+
Add to wish list

US$112.35
This kit can be used to demonstrate most of the principles of electricity. Supplied with an easily understood instruction manual. The kit contains the following: Voltmeter 0-1.5; 0-3v, Milliammeter 0-500 mA; 0-1000mA, Electroscope, Battery Kit, Mini Rheostat, Two Bar Magnets 2" in length, Compass Needle, Two Resistors, Mini Electromagnet, Horseshoe Magnet, Two Mini Contact Switches, Two Bulb Holders, Package of Iron Filings, Battery Holder D-Cell, Coil of Wire, Steel Rod Electromagnet, Acrylic Piece 19mm x 120mm, Two Plastic Rods 5mm x 120mm.
In stock
+
Add to wish list

US$107.80
This is a 4 piece high quality Precision Measurement Set in a high impact reusable plastic storage container. Includes: 1-Micrometer 0-25 x .01mm. 1-Vernier Caliper 150 x .05mm. Knife edge square 90 degrees. Ruler Steel 150mm.
In stock
+
Add to wish list

US$107.73

With the Alternating/Direct Current Generator you simply turn the handle and a current is produced that illuminates a lamp mounted on the generator base. Specially designed commutator switches between AC and DC current generation. Open construction allows visibility of all the parts. Magnet polarity marked "N" and "S" for easy reference. Can be removed and remounted with the opposite polarity. Binding posts allow external meters to be hooked up to generator. 

Delivery within 2-3 weeks
+
Add to wish list

US$59.00
Unit has a high-power silicon cell which converts light directly into electricity to operate a motor. Exceptionally high output 1/2v with 300 milliamps of current output in bright sunlight. Solar cell approximately 2" x 3" with plastic diffusing lens and protective mounting. Motor with special anti-friction bearings revolves approximately 400 RPM in bright sunlight.
In stock
+
Add to wish list

US$56.21
These Barnes dropping bottles are square bottles made of heavy clear glass with a pipette and rubber bulb stopper.
In stock
+
Add to wish list

US$53.90
These Laboratory Scissor Jacks are great for supporting glassware and other lab items at a stable and precise height. The jack will extend to a maximum height of 10 inches. These Scissor Jacks come in Black enamel finish or Stainless Steel.
In stock
+
Add to wish list

US$49.28
The 1/2" thick vacuum plate was designed to fit any jar 8-1/2" O.D. or smaller. A rubber gasket is also included. 9" outside diameter.
In stock
+
Add to wish list

US$46.20
Constructed of heavy gauge aluminum to prevent corrosion and collapsing under a vacuum. Consists of a boiler, sample cup, tripod and two rubber stoppers with and without hole. The boiler is 100mm diameter x 170mm height, the stand measures 240mm in height. Requires a bunson burner or hot plate. (5" x 11-1/2" x 6").
In stock
+
Add to wish list

US$43.89
These cylinders are autoclavable and molded from tough translucent polypropylene with a a broad base for stability and raised graduations for easy reading.
In stock
+
Add to wish list

US$43.12

These Bomex Glass Brand Separatory Funnels have a conical shape, with ground glass Stoppers and Stopcorks.

In stock
+
Add to wish list

US$38.50
Includes: Three friction rods: one hard rubber, one hollow glass and one half ground glass. Four pads: one fur, one flannel, one silk, and one wool. 3 balloons and 10 feet of string. Instructions provided. (8-1/4" 1").
In stock
+
Add to wish list

US$38.50
These are nickel plated brass hooked weights. The hooks allow you to hook the weights in tandem.
In stock
+
Add to wish list
1 2 3 4 5 6 7 8
2 - 10