Ginsberg Scientific Inc.

1 2 3 4 5
US$15.40
This demonstration unit graphically illustrates the inertia of an object. Rest the plastic ball on top of the plexiglass square that is set on the vertical post. Release the spring and the square shoots out. The ball falls into the concave recession in the post, remaining at rest on top of the post as if nothing happened.
In stock
+
Add to wish list

US$15.18
The Fulcrum Holder is a metal support and cast iron base only. Dimensions: 3-3/4"" x 3-3/4" x 6-1/2".
In stock
+
Add to wish list

US$3.23
The Metal Balance Clamp slides on and locks to any meter stick. The removable stirrup can be used for suspension of weights.
In stock
+
Add to wish list

US$46.20
Constructed of heavy gauge aluminum to prevent corrosion and collapsing under a vacuum. Consists of a boiler, sample cup, tripod and two rubber stoppers with and without hole. The boiler is 100mm diameter x 170mm height, the stand measures 240mm in height. Requires a bunson burner or hot plate. (5" x 11-1/2" x 6").
In stock
+
Add to wish list

US$3.85
The Electroscope Foil Leaves are for any Electroscope. Pack of 12. (1/4" x 1").
In stock
+
Add to wish list

US$112.35
This kit can be used to demonstrate most of the principles of electricity. Supplied with an easily understood instruction manual. The kit contains the following: Voltmeter 0-1.5; 0-3v, Milliammeter 0-500 mA; 0-1000mA, Electroscope, Battery Kit, Mini Rheostat, Two Bar Magnets 2" in length, Compass Needle, Two Resistors, Mini Electromagnet, Horseshoe Magnet, Two Mini Contact Switches, Two Bulb Holders, Package of Iron Filings, Battery Holder D-Cell, Coil of Wire, Steel Rod Electromagnet, Acrylic Piece 19mm x 120mm, Two Plastic Rods 5mm x 120mm.
In stock
+
Add to wish list

US$392.00
This is perfect for classroom demonstrations of the effect a load has on a power source. The field of this magneto consists of a single Alnico magnet, which has a strong magnetic flux density. Capable of producing higher voltages then cobalt-steel magnets. The generator is mounted on 7 5/8" x 12" wood base with incandescent lamp and socket used as a load. Two binding posts are placed on the board for attaching other loads. Complete with instructions. (16" x 8" x 6"; 6Ibs).
In stock
+
Add to wish list

US$107.73

With the Alternating/Direct Current Generator you simply turn the handle and a current is produced that illuminates a lamp mounted on the generator base. Specially designed commutator switches between AC and DC current generation. Open construction allows visibility of all the parts. Magnet polarity marked "N" and "S" for easy reference. Can be removed and remounted with the opposite polarity. Binding posts allow external meters to be hooked up to generator. 

Delivery within 2-3 weeks
+
Add to wish list

US$27.25
This DC Hand Generator is a versatile generator and a perfect power supply for many experiments. This pistol grip style handle generator can be utilized with almost any experiment requiring up to 12-volt DC current. Housed in tough clear plastic.
Delivery within 2-3 weeks
+
Add to wish list

US$6.93

This conisists of five 2" x 2" Acrylic Color Filters ideal for optical transmission, measurements, solar monitoring, attenuation of laser beams and demonstrating laser light's monochromatic character.

Delivery within 2-3 weeks
+
Add to wish list

US$4.62
These Tubular Spring Scales are calibrated in both Grams and Newtons with transparent bodies and each size is color coded for identification.
Delivery within 2-3 weeks
+
Add to wish list

US$3.99
Consists of 52 pieces of: 40 of 1 gm masses, 8 of 5 gm, 4 of 10 gm. These masses are excellent for teaching weighing concepts. Molded from durable plastic with recesses so the masses are stackable and color coded to correspond with the value of each mass. The weight value is also molded into the top of each piece.
In stock
+
Add to wish list

US$4.62
These are a set of porcelain Mortar and Pestle.     Order#   Capacity   Rim dia  7-1302-20...
In stock
+
Add to wish list

US$23.49

The flame can easily be controlled higher or lower by rotating the ratcheted wick control wheel. The air cap is securely attached to the burner by a matching polished chain. Dimensions: 3.5" tall. 2.75" in diameter. 150ml capacity.

In stock
+
Add to wish list

US$8.09

The Two Way Burner Stand is ideal for use with alcohol burners. The base is made from 3/16" stainless steel rod with a plated steel mesh top. Stand can be used in either high or low positions.

In stock
+
Add to wish list

US$20.79

These Boston Round Flint Bottles with Dropper Assemblies are made of non-porous glass and autoclavable.

In stock
+
Add to wish list

US$6.09

The uncalibrated Specific Gravity Bottle, 25 ml, is made of borosilicate glass with ground stoppers for a precision fit.

In stock
+
Add to wish list

US$6.93
Size: 7 X 60 mm, 1/2 oz. Description: 18/400. The bulbs are made from a synthetic material and do not contain latex.
In stock
+
Add to wish list

US$5.70

These Dropper Bulbs can be used with pipettes and syringes.

In stock
+
Add to wish list

US$9.24
This is a polished aluminum clamp which will rotate and lock into any position. The clamp will hold a standard-size thermometer securely to a support rod. The clamp will accept rods up to 1/2" in diameter, and will rotate 360 degrees and lock into place.
In stock
+
Add to wish list

US$3.08
These are hooks collars that are very versatile to support for various lab experiments. Great for suspending pulleys and spring scales.
In stock
+
Add to wish list

US$1.08
The Mohr's Pinchcock Clamp easily fits over standard size tubing to effectively clamp off hoses and control the flow of solutions.
In stock
+
Add to wish list

US$2.31

These screw form Hoffman Clamp allows added control by a screw type adjustment which allows more or less air or liquid through.

In stock
+
Add to wish list

US$128.98

With this distillation apparatus you can separate any mixture of two liquids by raising the temperature of the mixture to a point where one of the liquids will boil but the other remains liquid. Consists of: 300mm Leibig Condenser. Kjeldahl Ball 50mm in dia. 500ml Boiling Flask. Cast Iron Base with Support Rod. Clamp. Cast Iron Tripod. Wire Gauze. 500ml Erlenmeyer Flask.

In stock
+
Add to wish list

US$18.48

Set contains twelve 3 1/2 X 4 1/2 polystyrene spot plates and each spot plate contains twelve 5.7mm depressions.

In stock
+
Add to wish list

US$16.87
The Graduated 5 ml Fermentation Tube is used for the fermentation of carbohydrates and for collecting and measuring the gases that are produced.
In stock
+
Add to wish list

US$7.32
This red rubber safety pipette filler is a bulb type filler. It has three valves which control the air release, liquid intake, and the dispensing of liquid through either a volumetric or Mohr pipette. The three valves are identified on the unit.
In stock
+
Add to wish list

US$3.85
These Bomex Erlenmeyer glass flask have a narrow mouth, tooled top finish, metric capacity scale and thick walls. Does not include stopper. These Erlenmeyer or conical Flasks are excellent for school laboratories.
In stock
+
Add to wish list

US$4.00

These Borosilicate Glass Cylinders come with removable stands for added stability and a bumper guard to prevent breaks.

In stock
+
Add to wish list

US$5.41
These are high quality Short Stemmed Funnels made of Borosilicate Glass.
Delivery within 2-3 weeks
+
Add to wish list

US$33.66
These Bomex Glass Brand Separatory Funnels have a conical shape, with ground glass Stoppers and Stopcorks.
In stock
+
Add to wish list

US$131.29

This 36 piece Glassware Kit contains all the essential borosilicate laboratory glassware. Included are the following: Griffin beakers, one 50ml, two 250ml and one 600ml -- Erlenmeyer flasks; one 50ml, two 250ml and one 500ml --six medicine droppers -- six stir rods 6" -- one graduated cylinder 10ml -- one graduated cylinder 100ml -- one serological pipet -- twelve test tubes 16x150mm -- one short stem funnel 75mm x 75mm.

In stock
+
Add to wish list
1 2 3 4 5