Ginsberg Scientific Inc.

1 2 3 4 5 6 7 8
2 - 16
CA$392.00
This is perfect for classroom demonstrations of the effect a load has on a power source. The field of this magneto consists of a single Alnico magnet, which has a strong magnetic flux density. Capable of producing higher voltages then cobalt-steel magnets. The generator is mounted on 7 5/8" x 12" wood base with incandescent lamp and socket used as a load. Two binding posts are placed on the board for attaching other loads. Complete with instructions. (16" x 8" x 6"; 6Ibs).
In stock
+
Add to wish list

CA$131.29

This 36 piece Glassware Kit contains all the essential borosilicate laboratory glassware. Included are the following: Griffin beakers, one 50ml, two 250ml and one 600ml -- Erlenmeyer flasks; one 50ml, two 250ml and one 500ml --six medicine droppers -- six stir rods 6" -- one graduated cylinder 10ml -- one graduated cylinder 100ml -- one serological pipet -- twelve test tubes 16x150mm -- one short stem funnel 75mm x 75mm.

In stock
+
Add to wish list

CA$128.98

With this distillation apparatus you can separate any mixture of two liquids by raising the temperature of the mixture to a point where one of the liquids will boil but the other remains liquid. Consists of: 300mm Leibig Condenser. Kjeldahl Ball 50mm in dia. 500ml Boiling Flask. Cast Iron Base with Support Rod. Clamp. Cast Iron Tripod. Wire Gauze. 500ml Erlenmeyer Flask.

In stock
+
Add to wish list

CA$122.43
The open front spring clips make it much easier to remove the test tubes while the tubes remain submerged. The test tubes have been graduated for a clear measurement of the volume of gas generated. The black acrylic background aids in viewing the water level while supporting the test tubes. The binding posts have been reposititioned for easy access and greater safety. The unit measures 140mm x 203mm x 38mm. Instructions included.
In stock
+
Add to wish list

CA$112.35
This kit can be used to demonstrate most of the principles of electricity. Supplied with an easily understood instruction manual. The kit contains the following: Voltmeter 0-1.5; 0-3v, Milliammeter 0-500 mA; 0-1000mA, Electroscope, Battery Kit, Mini Rheostat, Two Bar Magnets 2" in length, Compass Needle, Two Resistors, Mini Electromagnet, Horseshoe Magnet, Two Mini Contact Switches, Two Bulb Holders, Package of Iron Filings, Battery Holder D-Cell, Coil of Wire, Steel Rod Electromagnet, Acrylic Piece 19mm x 120mm, Two Plastic Rods 5mm x 120mm.
In stock
+
Add to wish list

CA$107.80
This is a 4 piece high quality Precision Measurement Set in a high impact reusable plastic storage container. Includes: 1-Micrometer 0-25 x .01mm. 1-Vernier Caliper 150 x .05mm. Knife edge square 90 degrees. Ruler Steel 150mm.
In stock
+
Add to wish list

CA$107.73

With the Alternating/Direct Current Generator you simply turn the handle and a current is produced that illuminates a lamp mounted on the generator base. Specially designed commutator switches between AC and DC current generation. Open construction allows visibility of all the parts. Magnet polarity marked "N" and "S" for easy reference. Can be removed and remounted with the opposite polarity. Binding posts allow external meters to be hooked up to generator. 

In stock
+
Add to wish list

CA$106.19
This is an amazing demonstration of the power of electromagnetism, capable of lifting up to 200 pounds. A strong enamel-covered electromagnet powered by four 1.5 volt C batteries. Equipped with alligator clip leads approximately 6" in length. The unit measures 75mm diameter x 260mm length. Batteries not included. Instructions provided.
Delivery within 1-2 weeks
+
Add to wish list

CA$73.99
Four stroke operation is demonstrated by the gear driven timing mechanisms, valves, ignition, systems and more. DC power input is available to power a lamp which represents the spark or glow plug ignition. Made from high density plastic that will withstand continual use.
In stock
+
Add to wish list

CA$72.77
The unit uses a nylon pendulum with a tapered rubber insert. Both pendulum and base have leveling screws. The spring-loaded gun has a self-locking trigger and rubber bumper to prevent damage on impact. The scale is marked in degrees and is registered by a counter-weighted needle that remains in place at the height of the arc.
Delivery within 1-2 weeks
+
Add to wish list

CA$70.84
These Laboratory Scissor Jacks are great for supporting glassware and other lab items at a stable and precise height. The jack will extend to a maximum height of 10 inches. These Scissor Jacks come in Black enamel finish or Stainless Steel.
Delivery within 1-2 weeks
+
Add to wish list

CA$66.22
Used for many demonstrations involving electric magnets or solenoids. A plastic spool is wrapped with three layers of 20-gauge magnet wire. A 1.8 cm diameter removable steel core is located inside the solenoid. Insulated binding posts are located at each end for application of an electric current.
In stock
+
Add to wish list

CA$59.00
Unit has a high-power silicon cell which converts light directly into electricity to operate a motor. Exceptionally high output 1/2v with 300 milliamps of current output in bright sunlight. Solar cell approximately 2" x 3" with plastic diffusing lens and protective mounting. Motor with special anti-friction bearings revolves approximately 400 RPM in bright sunlight.
In stock
+
Add to wish list

CA$56.21
These Barnes dropping bottles are square bottles made of heavy clear glass with a pipette and rubber bulb stopper.
In stock
+
Add to wish list

CA$53.90
Contains all the necessary components to demonstrate the relationship between length of the lever arm, moment of force, and amount of force. When they adjust weights on the lever to establish equilibrium students will observe the law of torque and its properties. Consists of a 50cm meter stick, stand, three knife-edge clamps, one 50 gram hooked weight and one 100 gram hooked weight.
In stock
+
Add to wish list
1 2 3 4 5 6 7 8
2 - 16