DC Fans - 5V

US$5.41
L9110 Module is a small fan that blows with enough strength to put out a lighter's flame 20cm away. 
In stock
+
Add to wish list

US$10.69
50X50X10mm 5VDC Brushless Cooling Fan Use this mini cooling fan to cool down the components on your PCB. Specifications: 5VDC 3-pin...
In stock
+
Add to wish list

US$2.68
25x25x7mm 5VDC Brushless Cooling Fan Use this mini cooling fan to cool down the components on your PCB. Specifications: 5VDC 2-pin...
In stock
+
Add to wish list

US$3.41

This is a 5 to 12 volt circular brushless fan @ 60mA measuring 54 mm from center mounting hole to mounting hole, comes with 3 pin JST connector.

In stock
+
Add to wish list

US$3.63

This device is a 30 x 10mm 5V Brushless Cooling Fan with 10 cm. wire 

In stock
+
Add to wish list

US$3.49
5V Cooling Fan 40mm x 10mm Specifications: 5VDC 2-pin JST connector 40 x 40 x 10 mm Rated Current: 0.11± 0.02 Amp Rated...
In stock
+
Add to wish list

US$2.79
Category: Jetson Nano cooling fan. Connector: 3PIN reverse-proof connector. Spec: 5V. Dimensions: 40mm×40mm×10mm.
In stock
+
Add to wish list

US$4.19
Category: Jetson Nano cooling fan. Connector: 4PIN reverse-proof connector. Spec: 5V, PWM adjustment. Dimensions: 40mm×40mm×20mm.
In stock
+
Add to wish list

US$27.93
This smart fan and power expansion board are designed for DIY makers, especially for Raspberry Pi lover, it is compatible with Raspberry Pi 3/ 2B/ B+. Built-in temperature sensor, with active cooling fan, you can control flexibly the ON/OFF of mini fan via I2C command and GPIO programming.
In stock
+
Add to wish list

US$3.49
This fan is specifically designed for Raspberry Pi and can be mounted on some acrylic cases. The fan is useful for projects where heatsinks just aren't cutting it. Protect your hardware with a low power fan. The greatest feature of this fan is its low power consumption (20mA @ 5VDC). This fan attaches directly to the RPi GPIO and requires no additional power source or relay circuit.
In stock
+
Add to wish list

US$6.13
Hook up this 5V Mini Cooling Fan and prevent your hard-working Pi from overheating! Of course, it's also great for use with any small computer or FPGA or motor driver or anything that needs cooling. Plug the fan directly into your Raspberry Pi's 5V+GND GPIO power pins, as shown, for instant cooling! Place in your case, or even better, on top of your Pi's CPU to give it extra air-flow. Compatible with any and all Raspberry Pi computers but only the Pi 3 runs hot enough to benefit from any cooling, when doing intense computations.
In stock
+
Add to wish list